View topic - Pertronix ignition

Pertronix ignition
Page 1 of 1

Author:  RonGlunt [ Fri Mar 24, 2017 11:04 pm ]
Post subject:  Pertronix ignition

I just installed a Pertronix ignition system on our 59 Firesweep. Do I need to bypass the ballast resistor for easier starting? Thanks.

Author:  paulpresnell [ Sat Mar 25, 2017 2:28 am ]
Post subject:  Re: Pertronix ignition

I would call Pertronix to check on this. I understand you can burn it up if not wired right.


Author:  TimBowers [ Mon Mar 27, 2017 4:04 pm ]
Post subject:  Re: Pertronix ignition

The little wiring diagram that came with the one we just received shows wire routing both ways.... "with" the resistor, and without.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group